Des Posted July 27, 2008 Report Share Posted July 27, 2008 Hey Hey, I bent an axle in my t18 and i bought a ra40 axle to fit in, I cut it down to suit and it fits in the housing ok but it doesnt bolt up. The plate with four holes in it doesnt match. Any one else had this problem or is it just me ? Quote Link to comment Share on other sites More sharing options...
Sam_Q Posted July 27, 2008 Report Share Posted July 27, 2008 well I am going to find out next weekend when I try and fit my ra40 axle, so what the holes are close or way off? Quote Link to comment Share on other sites More sharing options...
Des Posted July 27, 2008 Author Report Share Posted July 27, 2008 well I am going to find out next weekend when I try and fit my ra40 axle, so what the holes are close or way off? Too far apart to make them fit. As in enlarging the holes so it lines up. Quote Link to comment Share on other sites More sharing options...
beerhead Posted July 27, 2008 Report Share Posted July 27, 2008 You'll need to pull the bearings off the axel and swap the bearing plate too :S Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.