warbuilt Posted April 8, 2016 Report Share Posted April 8, 2016 we have been dropped off a KE 10 for rust /panel /paint and rotary conversion . we have gone to fit the rotary but there is not enough room to the suspension crossmember to get the engine low enough to clear tunnel . we have cut out a bit of firewall and tunnel but even so , the gearbox needs to come up so far that we have to cut out floor cross brace etc. it would make more sense if we could buy or modify suspension cross member . has any one done this conversion ? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.