Difference between revisions of "Removing Spigot Bearings"

From Rollaclub
Jump to: navigation, search
 
Line 3: Line 3:
 
This is a top tip on how to remove a tough to remove spigot bearing.
 
This is a top tip on how to remove a tough to remove spigot bearing.
  
- Pack a bunch of grease through the centre hole of the bearing
+
1. Pack a bunch of grease through the centre hole of the bearing
  
- get a bolt or piece of rod, or if you have an old input shaft end that you use as a clutch alignment tool and insert it into the centre of the bearing
+
2. Get a bolt or piece of rod, or if you have an old input shaft end that you use as a clutch alignment tool and insert it into the centre of the bearing
  
- Tap the shaft with a hammer a few times. If it doesnt start to move, pack a more grease in (has to be jammed full)
+
3. Tap the shaft with a hammer a few times. If it doesnt start to move, pack a more grease in (has to be jammed full)
  
- Tap some more until the bearing pops out.
+
4. Tap some more until the bearing pops out.
  
 
Unlike a gas (air) grease is incompressible, as you put force on it it will try force its way out. If the bearing is the path of least resistance, then she'll just pop out.
 
Unlike a gas (air) grease is incompressible, as you put force on it it will try force its way out. If the bearing is the path of least resistance, then she'll just pop out.

Revision as of 09:34, 12 September 2009

--Philbey 23:15, 21 May 2008 (EST)

This is a top tip on how to remove a tough to remove spigot bearing.

1. Pack a bunch of grease through the centre hole of the bearing

2. Get a bolt or piece of rod, or if you have an old input shaft end that you use as a clutch alignment tool and insert it into the centre of the bearing

3. Tap the shaft with a hammer a few times. If it doesnt start to move, pack a more grease in (has to be jammed full)

4. Tap some more until the bearing pops out.

Unlike a gas (air) grease is incompressible, as you put force on it it will try force its way out. If the bearing is the path of least resistance, then she'll just pop out.

From this original discussion thread.

http://www.rollaclub.com/board/?showtopic=33912