hey guys, pretty easy one,

 

just after the size of the thread etcetc of the 4age/4ac water temp, the thing that goes screws in at the front of the motor cause I need a bung to fit an aftermarket temp gauge.

 

need to know asap.

 

cheers,

M16x1.5mm thread. you can buy the M16x1.5mm to 1/8npt thread adapters at Supercheap Auto, part number is CAL320055 and they are the "Calibre" brand. You'll find them on page 9 of the catalogue: http://media.superch...erformance.pdf.

 

ps. there is a spare M16x1.5 port in the external thermostat housing that has a bung in it, that's where I put aftermarket temp gauge sensor, that way you have both temp gauges incase one stuffs up.

 

Have a look at my thread, about halfway down the page you'll find what I'm talking about: http://www.rollaclub...d/page__st__315

Edited September 13, 201214 yr by rian

cheers man,

 

um yeah i don't run a external thermostat setup on my smallport, so I'm just going to hook it in where the factory one was at this stage...

Edited September 13, 201214 yr by cicca_294