Ke11 Rims

[pol090_ke11]

Hey Guys wondering if a set of 15x7's on the front and 15x7.5 on the rear would fit under a ke11

 

And just double checking the stud pattern for a 1970 ke11.

[Jono.C]

stud pattern is 4x110

 

ke30 and ke70 etc is 4x114.3

 

not sure on the wheels fitting it depends on what offset they are..

 

Cheers

[pol090_ke11]

cheers for that Jono.C

 

How can i figure out what offset I need to run?

[Jono.C]

You can use online programs like

 

http://www.willtheyfit.com/

 

and input your wheel size now aand offset adnd your new wheel size and offset and it will tell you how it will fit.

 

 

For example 15x6 0 offset rims will sit 30mm closer to the guards that 15x6 +30mm

 

Cheers

[Jordain]

I believe I have 15x8 on rear and 15x7 on front although..... on the front they hang out heaps. I have a set of 15x5.5 and they sit flushly.

[pol090_ke11]

Jordain have you any pictures from the rear of the car and front?

[Jordain]

 

[pol090_ke11]

thanks heaps for that mate did you have to move the rear leaf springs towards the centre to get those to fit under there or they fit ok? and are you going to pump the guards or are you going to use a set of wheel arches or get a less wider wheel? but other than that they look really good :y: well done.

[Jordain]

Rear guards have been cut done, tig welded up and had 4x5mm flatbar welded to the edge because I wanted the guards to be circular. as you see in the above pic ( where its in primer ) the cars rear guards aren't circle and look shit in my opinion. They were also pumped out about an inch in the rear. For the front, Plan on leaving it like that, Just going to run cambe tops and LCA's and get i'll crank some camber on ;) hahahaha, get a defect.. just chuck some stockies on it :fuzz: