July 4, 201115 yr comment_537197 we had the springs out completly we wanted to see how low it was on bump stops it was still legal at 115mm from the ground at the lowest point the limit is 100m so yeah good times Report
July 4, 201115 yr comment_537302 yea i'm not against spring cutting.. not really a fan of it either but... as long as decent stiff shocks are used i reckon its fine.. and i normally cut two things off the rubber bump stops when cutting springs.. so it still has a bit of travel in it. Report
July 10, 201115 yr Author comment_538698 Ok crosmember is done and fuel system in 90% done now i need to extend the tailshaft was thinking of cutting the ae86 and ke70 shafts and machining a piece to fit inside each and extend it 40mm then weld it in has any1 done tailshaft extentions before and will it need balancing? Report
July 10, 201115 yr comment_538724 Just take it to a shop mate, all of their fab work will be covered by some kind of warranty and they will do it once, and do it right. I'm not doubting your fabrication skills, just for the little expense they charge it will give you peace of mind. Best of luck with it! Report
July 13, 201115 yr comment_539319 hey mate just wondering what clutch setup you have running for the 4age needing to do one for mine and would be very helpful Report
August 6, 201115 yr Author comment_544923 havnt been on here in a while but thanks to my new mate Dan the 4age is finally alive :D and ridley the clutch is a stock ae86 as far as i know Report
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now