2Tg Into A Ke20

[johnsparty09]

Anybody have any tips on putting a 2tg into a ke20?. I'm about to start the conversion but not a hundred percent sure what would this entail and if the engine and t50 gearbox will bolt straight in.

[parrot]

Here is something to get you started

 

http://www.rollaclub.com/board/topic/47108-2tgeu-into-ke20/page__st__15

[modify]

It will bolt straight in with a te2# engine crossmember and engine mounts. :)

 

Plus you will either need to find a forward selector t50 or extend you shifter hole in the driveshaft tunel closer to the hand brake to acomidate the rear selector t50.

 

The standard ke2# gearbox crossmember is the same as te2# and bolts further back in the chassis rails so no mods there.