Hey everyone new to the page. Has anyone ever fitted a 4 link and chassis clip in a ke70. Looking for some contact and info on where I can get one. We have tried McDonald brothers racing but wondering if there is any other options in Australia 

Pro9 do them, but I can't see they do any better than the 5-link that's in there.  Nissan ran the 4-link with angled arms in their 1980s cars, we always thought it was a compromise as the arms fight against one another when the suspension goes up and down.

http://www.pro9.com.au/?PCID=10796&PSO=259&PSID=Pro9-4LK1000VT&PSV=Primary&CDO=

Pro9 have parallel links and a diagonal locating arm instead of  a panhard.

You planning some big horsepower?

Yeah we are building it as a drag car. Keeping with the Toyota theme we are going to be running a 1kd around the 500hp mark and 1000nm at the wheels so we need a rear end to cope.

Edited May 6, 20197 yr by Bobalong

makes sense then- you won't be worrying about wheel travel as much as torque twisting one rear wheel right off the ground.

Try http://www.lauriamotorsport.com.au

Or Next Gen race cars in Hallam Victoria. 

Either should be able to point you in the right direction. 

Cheers every one. We spent a few hrs last night under the back with a  pen and a tape checking it out, we are going to try and build our own set up.