Hey Hey,

 

Ive got ke25 hubs and the bearings on the wheel mounting side fell out, And the other side wont f@$king come out.

 

Are they pressed fit and not replaceable or am i just being a little girl ?

 

Des :bash:

Edited June 5, 200719 yr by AE70

You're just being a girl. LOL :bash:

 

You need to remove the seal first to remove the inner bearing.

 

The bearing races need to be drifted out if you replace them.

You're just being a girl. LOL :bash:

 

You need to remove the seal first to remove the inner bearing.

 

The bearing races need to be drifted out if you replace them.

I want to replace it all as they are about 30 or so years old, Drifted out ? Do you mean hooking around corners or some other way ?

 

Des :cool:

Edited June 5, 200719 yr by AE70

grab a suitable length of bar, insert through the front of the hub until it sits on the rear bearing, then wack with a hammer. keep moving to different spots so it comes out evenly.

Thanks fella's, Will let ya's know how i go tomorrow sometime.

 

Des :bash:

Edited June 5, 200719 yr by AE70

If you pull the outer bearing out, clean the inside with a rag, and you'll see that the lip on which the bearing sits has two cut outs 180 degrees apart. Pin punch and hammer will work it out.