hey guys

 

tonight i put on my new wheel cylinders and my new shoes on my ke35 and everything went to plan,

bleeded my breaks and then thought how do i adjust my drums to the right friction,

I'm thinking i roar down my street backwards then slam on the peddel and hopfully they will adjust them selfs

then slowly crawl my way down do the local garage.

 

what should i do

 

Thanks, Lukey :lolcry:

KE35's should have self adjusting rear brakes. Think they're supposed to adjust themselves up when you reverse and pull on the handbrake.

Yeh, that trick usually works - just put the Handbrake half on and reverse a couple of metres. Should wind them out nice.

 

My bluebird ones didn't do this though, so I had to jack the wheel up and poke a screwdriver in through the back of the drum to wind a little adjuster knob. All you do is wind it up til the wheel doesn't turn, then back it off slowly until it frees up again.

 

Front drums usually have a nut on the back to do this.

way i was told to adjust them was:

 

have the motor running, pull up the handbrake, push on the foot brake, relise the hand brake relise the foot brake.... or maybe its the other way around...

 

dunno but my hand brake dosnt lock that well anymore, too many drifs

hey thanks guys tomoz morning I'm going to adjust the drums IF THE f@$kER STARTS

thanks heaps Lukey

there 'supposed' to self adjust.. however they rarely do in practice.

 

you wont need the engine running. to adjust:

 

1. loosen off handbrake

 

2.take drums off and remove excess brake dust. don't breathe the shit, and wash down with water/brake clean.

 

3.while your there, check the adjuster, make sure its not seized, check which way you have to turn to tighten and loosen, and see if theres a plate that holds the adjuster wheel you have to push to loosen.

 

4. put drums and wheels back on, or drums and put wheel nuts back on and tighten them on the drum (keeps the drum square with the brakes)

 

5. adjust drums till you can barely move the wheels, then loosen till you can only 'just' hear the shoes scrape on the drums when you spin the wheels. if theres a plate that holds the adjuster wheel in place ( i forget the technical term) you may have to push on that through the adjuster hole while loosening.

 

6. put wheels back on if you didnt in step 4. adjust the handbrake till its where you like it (4-6 clicks is good, but may like more for more 'leverage') :lolcry:

 

7. test drive car. go somewhere theres no cars around and do a few 60-0kmh crash stops. feel the way the rear end pulls up. if it feels like its too front biased, adjust up the rear brakes about 2-4 clicks at a time till its braking evenly.

 

if it feels like its braking rear biased, or is locking up early, loosen 2-4 clicks until it brakes evenly

 

if it feels like 1 sides braking more than the other ie 1 sides locking befor the other, either tighen or loosen 1 side 2-4 clicks at a time until it pulls up evenly.

 

if you have to adjust them up more, double check how much the rear shoes are scraping on the drum. there shouldnt be enough resistance that the wheel can't do 2 full rotations with just a 'flick' of the wheel. if there is too much resistance and you don't loosen them. you'll cook the brakes

hth

Edited June 21, 200818 yr by MRMOPARMAN