Hey I'm chasing a 4k-e efi wiring loom, or someone to make me a loom. Any ideas or suggestions

my job at work is wiring looms i could make you one if you like

What ECU do you have?

I'm really chasing a factory loom to start with, as I just brought this set up

 

http://www.trademe.co.nz/Browse/Listing.aspx?id=380648410

 

and it doesn't come with any loom, so no sensor plugs or ecu plugs.

 

you can see ecu in picture

I'm really chasing a factory loom to start with, as I just brought this set up

 

http://www.trademe.co.nz/Browse/Listing.aspx?id=380648410

 

and it doesn't come with any loom, so no sensor plugs or ecu plugs.

 

you can see ecu in picture

i would just put aftermarket computer in it that computer will be shit not much better then carb

Did you even get the air flow meter?

 

Factory ECU is probably not going to be any good if you didn't get the full kit..

yeah i would give up on that old outdated factory ecu i have heaps of ecu's here and we are a haltech dealer

Yea got afm just missing wiring loom

hey mate if i did the loom it would look like this http://www.rollaclub.com/board/topic/52058-supercharged-4k-motec-injection/

hey mate if i did the loom it would look like this http://www.rollaclub.com/board/topic/52058-supercharged-4k-motec-injection/

 

Mitch-12 are you still making these wiring harness. I'm looking at doing the same conversion but I do not have any sensors or ecu atm how.much would it cost to have one made up if you supplied ecu. And sensors to the same configuration as your harness. I'm goig 5k efi with 7k intake manifold with sc12 or 14sc