Old fella Posted June 20, 2011 Report Share Posted June 20, 2011 G`day all, I am about to fit a set of bottom end bearings to my FJ62 Landcruiser and am wondering if anyone knows if the oil pump can be shimmed like a 4k to give me a bit better pressure. A new pump is way out of my budget at the moment at over $350.00. Its possible that the new bearings will fix the low pressure problem but I want to be prepared if it doesn`t. The engine has done 370,000k and is in good condition and will only be getting a sump off repair. The oil pressure has been slowly dropping over the last year or so, so I don`t actually suspect the oil pump. Cheers. Sorry if this offends mods. I couldn`t find anywhere else to post it and I know that there are a couple of Toyota Technicians on here regularly. Quote Link to comment Share on other sites More sharing options...
Evan G Posted June 20, 2011 Report Share Posted June 20, 2011 have you measured the crank and bearings to see if theres a correct oil clearance? i think its .03 basic rule of thumb (if my memory serves correctly) Quote Link to comment Share on other sites More sharing options...
love ke70 Posted June 20, 2011 Report Share Posted June 20, 2011 plasti-gauge it and stop being a tight arse, put the new pump in, just don't go to the pub for a fortnight, its gonna need one, your kidding yourself that it wont... 1 Quote Link to comment Share on other sites More sharing options...
Evan G Posted June 20, 2011 Report Share Posted June 20, 2011 if you can't afford a new pump atleast check the tolerances on the rotor and pump to give you a good indication if its fubar or ok Quote Link to comment Share on other sites More sharing options...
altezzaclub Posted June 20, 2011 Report Share Posted June 20, 2011 check the tolerances on the rotor and pump X2 and if its still within limits but worn, there will be a pressure relief valve that you might be able to shim. Quote Link to comment Share on other sites More sharing options...
Old fella Posted June 20, 2011 Author Report Share Posted June 20, 2011 Thank you gents for your valued comments. Now for some of mine. A. I`m not a tight arse as suggested, I am simply short of the ready stuff at the moment and need to have the car on the road asap. Haven`t we all been in that situation????? B. Unlike some, I don`t consume alcohol or "go to the pub" as it were.. C. The engine has never been mistreated and I know the full ownership details since new. The crankshaft is perfect and is getting a set of standard bearings as per plastigauge readings. D. The pump is visually ok. I would not consider putting it back in if it were not. It will be checked properly first. E. The initial question related to whether or not the pressure relief valve could be shimmed for better pressure. I have since found my missing workshop manual and, indeed it is a simple job to do. Thanks for all of the posts, but Jeez some of you carry on. Quote Link to comment Share on other sites More sharing options...
altezzaclub Posted June 20, 2011 Report Share Posted June 20, 2011 Well, we're only here to help you know! :P Quote Link to comment Share on other sites More sharing options...
love ke70 Posted June 20, 2011 Report Share Posted June 20, 2011 people that don't drink, theyre always so tightly coiled :P no offense was intended, its just my experience, and ill refer to previous comments ive made in other threads about needlessly increasing maximum oil pressure... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.