Flywheel And Clutch Questions

[red mango]

i tried searching through the forums already but i need some confirmation on the following before i buy the parts:

 

i already have a 4agze afm (with dli) engine.

i already have a t50 from an a series engine.

i already have a spigot/pilot bearing

 

1) i plan to get a 212mm flywheel from 20v silvertop 4age (advantage also of being slightly lighter according to some posts). this should fit my tranny right?

 

2) can i use a fwd (from 20v silvertop also) clutch system (i.e. pressure plate, clutch disc, release bearing) with my tranny?

 

anything else i missed, please let me know.

 

thanks guys. :y:

[Sam_Q]

yeah all sounds good except for the clutch release bearing. I don't know but I would take an educted guess and say that you specificly need the T50 one

[Trev]

Make sure you turn the plate between the box and the motor around as the gze starter needs to go on the other side.

[Des]

I'm using the same flywheel on my gze to t50 and I'm using a RPM 212mm (215mm in the repco books) clutch with a stronger pressure plate, The clutch itself is ment to be for a AE92 100kw smallport 4age.

 

You just need the ae71 or ae86 throw out bearing (you should have but also should replace) and the spigot bearing.

[red mango]

many thanks for inputs.

 

i got a flywheel from a 20v as well the matching pressure plate and clutch disc. also got the release bearing for rwd and the spigot bearing.

 

trev - thanks for the tip re the plate.