is it posible to put 4agze pistons onto 3rib 4age rods???

is it posible to put 4agze pistons onto 3rib 4age rods???

 

No, Different gudgeon pin diameter.

what about the earliest model 16v gze's aparently there 18mm and the 3 rib big port i have is 18mm gudgeon pins arent they

what about the earliest model 16v gze's aparently there 18mm and the 3 rib big port i have is 18mm gudgeon pins arent they

 

No, the early GZE's are a 20mm, The only 4age to have the 18mm is the 3 rib bigport.

No, the early GZE's are a 20mm, The only 4age to have the 18mm is the 3 rib bigport.

 

oh ok yeah i have a 3rib bigport 4age and was only wondering because i am turboing it

Edited March 30, 200917 yr by mr ae71

oh ok yeah i have a 3rib bigport 4age and was only wondering because i am turboing it

 

Buy my GZE then.

still payin off the 4age atm lol

You could do an N/A Turbo setup, but you'd want to be VERY careful with your tuning and running about 5psi boost so you don't blow a hole in the piston from detonation.

yeah but while the car is in pieces it will be easier to build the turbo motor setup block the way i am thinkin about it atm i am goint to build the 3 rib big port with a turbo then if it sends a piston through the block then i will use a 4afe block and put forgies through it

how about you do it once and do it properly, else just give me the $ you're gonna be spending and save you the pain for building 2 motors that'll blow up.

how about you do it once and do it properly, else just give me the $ you're gonna be spending and save you the pain for building 2 motors that'll blow up.

 

 

so your suggestion is good sir/madam :wink:

yeah gze would be a lot less screwen around

Edited April 4, 200917 yr by ae174agze