toyrota

Yeah it would look heaps better painted in faded rusty orange like your 120Y Gaymobile :)

The guy's daughter wasn't born when he built it!

What are you thinking using square U-Bolts? they are meant for square trailer axles not round diff housings..

If you run an RX4 bell housing you wont need to change to 9.5in clutch. So for an extra 200 or so bucks plus a bellhousing u'll know you wont be walking home when you're 30 yearold box craps itself

You need to cut about 2 to 2-1/2 inches deep out of the x/member so the sump will clear. and then put the strength back in with a few braces and some plate. i'll try to find some photo's of mine when i made it and put them up.

don't waste you're time with a 12a, get a 13b. especialy if you're going n/a. u'll want a series 4 RX7 turbo gearbox with an RX4 bellhousing. These are a realy strong box and are fairly big but you wont break one. you shouldn't need to cut you're firewall either. i didn't in my ke55 and you would think a t18 would have to have a bigger tunnel? you will probably need to cut a fair chunk out of you're x/member aswell to get the motor sitting a bit lower and further back.

Sorry fella's. i meant something more around the $500 mark. 0407 349 635

I'm after something cheap to drive to work. prefer Datto 1200sedan/180b/200b, corolla or similer. (NO 120Y's) tho. must be still in reg and not half rooted because i can't realy be stuffed working on it. prefer in the Launy area.

hey people. i'm still after a chrome bonnet strip for a ke55. i need the skinny one piece one off the 80 model tho, not the big ugly one off a 79 model. must be in prime condition tho. thanks.

here's a couple of pics

nah it wasn't that that snapped the shaft. i'll have to show you how it happened.

did you get the undersized supercharger pulley with the car when you bought it?

point taken.

ooooops sorry. I'm only offering this item to my two headed brothers and sisters in Tasmania. could you kindly move this thread back to the Tassie section? Thanks

8in round 16in long 2-1/2in inlet 3-1/2in stainless dump this isn't a cheap Ricey look cannon muffler, it's a genuin Rotaflow. heavy duty design with stainless packing. looks tuff as. only selling because i need 3in straight through. It's only about six months old. They are about $400 new but am willing to sell for $150 0407 349 635