Search the Community
Showing results for tags 'tacho'.
Found 3 results
Ok so, A little while back i did an electronic dizzy conversion on my ke70, (which ill actually write up a guide for due to the internal ignitor) and ive made my tacho not work anymore. Everything else on the cluster works fine, lights gauges etc. I was wondering if in the engine bay however there is a tacho wire that runs to the coil thats ive cut through at 3am by accident weeks ago. If anyone could provide assistance through pictures, ill owe you a crisp high five Cheers ~Ethan
Recently installed a 2" tacho in my ke30. This is the one i got from ebay for $30 + $8 postage. "Tachometer 2'' Gauge Wide Sweep 250degree reading 4-6-8 cycl adjustable In Dash" from seller "automotiveblitz". http://www.ebay.com....id=300880814731 Decided to put it where the clock would normally go Made up a simple aluminium plate to hold the tacho in place With tacho bolted in Wired both ground wires and the orange (light) wire to some plugs that would have been used for the clock. Red wire will hook up to plug in photo below, green wire goes to the ignition coil Don't know what this plug is normally used for, but is very handy for the tacho Routing the wire from the dash into the engine bay via this rubber collar was pretty tough, anyone got some tips/tricks for doing this? Blue wire connects to negative terminal of ignition coil (this is the green wire from the instrument cluster) This post is pretty much what I was looking for when contemplating adding the tacho (since my automotive/electrical skills aren't great), so i hope somebody else finds it useful.