hey i was just wondering what front springs everyone uses in there ke3x's? my 36 had custom cuts in thr front, and just put some pedders in but the lowest pedders said they had was 1.5" lower and now my car is sitting at least and inch higher then it was before if not more. was just wondering what everyone else uses and what's the lowest ones you can actually buy for them?

 

Cheers Matt

Get custom springs made to suit the exact height that you want.

265mm free height should get you 5mm off of lowest legal height (at least in SA).

 

Thats what i got ready to go into my 30.

bout a 3 point something inch drop i think

Are the springs sitting properly in their perches?

they sit right. probably not captive with stock shocks of course. Been told to just wire the springs in to stop them fallng out and that was info from a Pedders man haha

So your pedders springs sit un captive meaning its just as unsafe as a stock spring thats been cut...

Use Slinky's :dance:

So your pedders springs sit un captive meaning its just as unsafe as a stock spring thats been cut...

 

They're kings that i got reset at work. The pedders man said to just wire the f@$kers in to stop them coming out.

Wow thats safe..... Just as good as the KE55 i seen with Zipties holding them in...

my current pedders are captive, but there not anywhere near low enough :bash: car sat at least another 1-1.5" lower before with the cuts in it lol. would i only need a shortened shock to suit if my spring was not going to be captive? or do the rolla's need a bit more then that?

"Wow thats safe..... Just as good as the KE55 i seen with Zipties holding them "

 

Nothing wrong with zip ties :bash: Held the cut springs in place on my first 'rolla for close to 6 years.

not liek they take any load.