yeah I'm thinking that taz

i would of went to deni if dad was home and my car went you are as fast as me now rob haha

I'm interested in the watts linkage, does it replace the panhard rod? DO you have to change anything else?

hey mitch, see u r making some real progress, will you have it ready for next race day? tomorrow me and pete probly going to deni to race on their track. Check it out on you tube it looks like full on race track but smooth dirt. I went 1.8sec quicker again at winton so down to a 1.45 now, not bad for 1.6lt corolla :)

 

 

If Deni is still as good as it was 10 years ago, it's probably the best Autocross track in the country. The place sets like concrete, and after you''ve knocked the top off the dust, it's super grippy and you end up leaving black marks on the dirt. Back in the day the locals used to use Yoko 008R tarmac tyres.

 

Used to get towelled each and every time by a Nissan March Supersport.

 

Good times. :)

pull the panhard rod out and cut the bracket off the diff put 2 new brackets on the diff and you need a rocker in the centre on the bracket ill take some pics tommorow to show everyone when its up on the forklift

my exhaust used to hit the ground so heres the solution not finished yet

finish it thursday when i get some more gas for the mig

also got my pumps and surge tank sorted

(mock up)

how it is now

and giving underneath a pressure wash

is that red one a donar car?

forklift = hillbilly hoist!!

red one is a donor sortof its my ls6 powered sportssedan when i get this black car done and we have a hoist but i can pressure wash in the shed haha

Mitch12 won't be rejoining us for a little while.

what happened?

I'm back and all good someone got on this computer and made an acc and shit went down lol anyway i have got a fair bit done this week ill let the pics do the talking

had a bit of a practise with the tig :)

My muffler box finished

the exit hole out the sill repair from the old exit hole fully low mate i had it outside while i cleaned the shed my custom arms that i am changing the one on the right in the pic (lhs) is twisted and cracked I'm going to a rosejoint adjustable setup and heres the watts link I'm gonna rosejoint that too and my exhaust 2.5inch mandrel bent straight through cost for exhaust $0 i made it out of second hand ones laying around and found all mandrel bends :) and injectors fitted not sure either 550cc or 660cc

you have been busy, i'm worried though that you don't have enough V8 blocks lying round in that workshop :rolls:

theres two under the bench in one of the exhaust pics :) other than that theres no more haha i havn't been earning any money for the past month with dad in the U.S