Doin a bit of panel repair on a KE55, guys how do i take off the winders? On my previous cars there was room for screwdriver to fit between the winder and panel to pop off the pin. On this one they are on so tight with almost no room between. Any ideas?

 

Thanks!

Tea towel or rag pulled tight and slid into the gap from the open side of the clip... I'm not describing this very well but it works.

ahhh think i got it, ill try that thanks

Yeah you need to floss with an open weave cloth behind the handle so you can catch the wire clip and pop it out of its groove.

Or $10 at Supercheap will buy you a tool that does the same job, and usually can be used to pop door trims off without tearing the clips out of the fibreboard.