Where did you get the flywheel? And how much was it if you don't mind me asking?

Where did you get the flywheel? And how much was it if you don't mind me asking?

 

The flywheel is made by Jun in Japan, I got this through a company in New Zealand that deal direct with Jun, I paid I think around £300 to £400 with taxes and shipping but I have seen them as much as $900!! Hope this helps

Are they stock 4k flat tops?

 

Are they stock 4k flat tops?

 

No these are 60 thou oversize pistons with compression raised to 11:1

 

https://www.facebook.com/ToyotaStarletKP61

Edited August 17, 201412 yr by Chingy

Nice build, so i imagine you need to deck the head along with those pistons to get 11:1?

Nice build, so i imagine you need to deck the head along with those pistons to get 11:1?

 

Thank you, yes head had been decked to up the compression. Now researching cams.

 

Looking at an Auckland Cams #566 profile which is a Wade 140 grind

 

Advertised duration: 290 degrees

Duration @.050”: 239 degrees

Cam lift: ..296”

LCA: 107 degrees

 

Open to suggestions.

 

Basic engine spec

Toyota 4k over bored by 60 thou to 1344cc

Compression raised to 11:1

Ported & Flowed head, valve seat job etc

Twin 40dcoe carbs

 

Car is used for occasion fast road use

 

 

Hi few more pics

 

https://www.facebook.com/ToyotaStarletKP61

 

 

 

 

 

 

 

 

 

 

 

Edited September 6, 201412 yr by Chingy

Hi as my build now gets well underway, can anyone help with what diff oil you should run in a TRD slipper as pictured here https://www.facebook.com/ToyotaStarletKP61

 

Thanks

If you right click the image, 'copy', then paste into your post you wont have to link your FB page all the time. As it is that link doesnt take us to the picture in question.

Sorry, I am using an IPad so have uploaded them to photobucket