4agze Pistons

[red mango]

how would i know if the pistons i have are from a ze?

 

there seems to be no product code on any part of the piston.

 

info/pics much appreciated. :D

 

thanks guys.

Edited January 8, 2007 by red mango

[red mango]

these are the pistons that my ze engine had.

 

notice that the one on the right doesn't have the "cuts" (clearance for valves?) on the head. i have visually compared the 2 pistons and them look identical in shape and size except for the cuts.

 

the 2 other pistons we pulled out are similar to the one on the left (with cuts).

 

is there any way of knowing if these are genuine ze pistons? or do i end up buying a new set to be sure?

 

 

help much appreciated. thanks.

Edited January 8, 2007 by red mango

[MRMOPARMAN]

easy way to tell, the factory GZE pistons had ceramic tops. GE's didnt.

[Foxtail]

They look like 3SFE pistons

 

4AGZE pistons are almost flat, but do have valve cuts.

 

[gearb0x]

Ive got no idea how to tell but i can offer photos (although slightly blurry) of the 8.0:1 CR factory GZE pistons that came out of my MR2

 

http://gb.detonated.org/gallery/engine-rebuild/DCP_3523

http://gb.detonated.org/gallery/engine-rebuild/DCP_3526

http://gb.detonated.org/gallery/engine-rebuild/DCP_3527

 

the 8.9:1's have flat tops, the lower compression ones have a dish

[Mr Revhead[RL]]

in your pics above, is the same piston on the left all the way through?

 

the left one looks like a genuina 8.0:1 4agze piston

the one on the right looks like an aftermarket one

the catch is on the bottom pic i can see ART on the underside

ART make the 4agze pistons for toyota

 

heres some pics i have of new 8.9:1 and 8.0:1

[red mango]

thanks a lot for the photos.

 

i went around the wreckers but all of them were unsure of the odd looking piston (the one without the cuts). as all of them recall the ze piston having cuts.

 

naturally, i don't want to have any problems later on (like engine won't start for starters) so i've decided to get another surplus block (with pistons and internals). luckilly, i was able to source out what looks like a relatively "fresh" one.

[kickn5k]

Correct me if I'm wrong but i thought that gze pistons must run oil squiter cutouts too or is that just for the 3sgte.

I just thought sets i have made had in the past had the cutouts about 45deg from the pin on the bottum of the skirt.

i may be mistaken your thoughts Cam?

[Mr Revhead[RL]]

only the 8.9:1 have the cut outs, you can see them on the right hand piston in my pics.

the pics at the very top of the thread are of 8.0:1 pistons which don't have cut outs