Hi Fellas,

 

I've been trying to figure out which radiator will fit in my KE55 with Sr20de. Measurements for s13 radiator if i set it hard up against the front would be too high for bonnet to close. Are there any alternatives with correct inlet/outlet orientation that will fit or should i try and fit the s13 radiator further back off the rail and put thermos on front?? What have you guys done. Cheers

If it's a stock motor the copper core standard ke radiator would probably do the job.

 

Ke70 guys use Excel radiators, not sure if they'd fit in a ke3/5* though.

Cheers mate

I suppose it depends on where your inlets and outlets need to be though. If the stock rad outlets will work you can get 3 core aluminum rads off eBay to suit.

Inlet should be on left looking at from drivers seat. Outlet on right. Do u know the standard ke55 radiator outside dimensions??

No idea sorry.

Check out this thread, see what Matt put in his.

 

http://www.rollaclub.com/board/topic/16608-matts-ke30sr20det/

I've got a repco radiator catalogue that says a KE3x, KE5x radiator is twin core, 467mm wide. The core is 300mm high plus you would need to add about 50mm each for the top and bottom header tanks.

Cheers parrot. I just found a Datsun 1600 radiator that should fit. Ports are on right sides too

I did this to my ke25 to make an s13 radiator fit further forward, would probably work on a ke30. It really depends how you feel about cutting the rad support panel, the datto radiator is probably more of a factory fit.

 

 

 

 

 

That looks great, what about the radiator cap, does it clear the bonnet??