CR250Roost Posted November 6, 2013 Report Posted November 6, 2013 Hey everyone, I just tried to mount the 4AGE to a T50 box. Only the two top bolt holes line up with those on the engine. Also there is a pin that lines up the engine, but the hole for that pin on the gearbox is on the opposite side. Is this a JDM/ADM issue? I know they differ by having the clutch fork on the other side, but I was told that any T50 box will fit as long as the splines are the same. Will a different bell housing fix this problem? Any advice is greatly appreciated! Thanks! Quote
Jordanrolla Posted November 6, 2013 Report Posted November 6, 2013 you might have a ta22 bellhousing Quote
springersrolla Posted November 6, 2013 Report Posted November 6, 2013 (edited) yeh id say you have a t series bellhousing u need a a series http://www.toymods.org.au/forums/engine-driveline-conversions/7521-series-bellhousing-old-t-series-transmission.html Edited November 6, 2013 by springersrolla Quote
CR250Roost Posted November 6, 2013 Author Report Posted November 6, 2013 That seems right... If only it wasn't so hard to find A-series bell housings :bash: Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.