CR250Roost Posted November 6, 2013 Report Share Posted November 6, 2013 Hey everyone, I just tried to mount the 4AGE to a T50 box. Only the two top bolt holes line up with those on the engine. Also there is a pin that lines up the engine, but the hole for that pin on the gearbox is on the opposite side. Is this a JDM/ADM issue? I know they differ by having the clutch fork on the other side, but I was told that any T50 box will fit as long as the splines are the same. Will a different bell housing fix this problem? Any advice is greatly appreciated! Thanks! Quote Link to comment Share on other sites More sharing options...
Jordanrolla Posted November 6, 2013 Report Share Posted November 6, 2013 you might have a ta22 bellhousing Quote Link to comment Share on other sites More sharing options...
springersrolla Posted November 6, 2013 Report Share Posted November 6, 2013 (edited) yeh id say you have a t series bellhousing u need a a series http://www.toymods.org.au/forums/engine-driveline-conversions/7521-series-bellhousing-old-t-series-transmission.html Edited November 6, 2013 by springersrolla Quote Link to comment Share on other sites More sharing options...
CR250Roost Posted November 6, 2013 Author Report Share Posted November 6, 2013 That seems right... If only it wasn't so hard to find A-series bell housings :bash: Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.