hey guys. not sure if this is in the right section BUT. wondering what sort of place i would have to go to to get a 2 inch straight through for my ke70. atm it does still have the 4kc if that helps at all?

Pretty much any reputable exhaust joint.

 

Nothing really of the shelf for them like late model cars.

ohh alright then. cheers man. i just wasnt sure so yeah. do u know if the rule is "cars made prier to 1985 don't need a cat?"

ke70 wont need one man but trust me if u can afford it get one makes a huge difference to the smell haha

ke70 wont need one man but trust me if u can afford it get one makes a huge difference to the smell haha

 

 

ohh sh&t really? i will only be a P plater so a bit of smell shouldnt be that bad... unless it is really bad? is it?

I always take a trip to the wreckers and get a full exhaust off a falcon or commodore..

 

Usually 2" - 2.25"

 

Just chop and weld to make it fit and buy a meter of 7mm steel rod to make hangers.

 

Costs about $35 for a full exhaust

 

Plus, if you get one with twin downpipes off the exhaust manifold, chop them up and weld them on the rear and you have a pair of drift tips ;)

I always take a trip to the wreckers and get a full exhaust off a falcon or commodore..

 

Usually 2" - 2.25"

 

Just chop and weld to make it fit and buy a meter of 7mm steel rod to make hangers.

 

Costs about $35 for a full exhaust

 

Plus, if you get one with twin downpipes off the exhaust manifold, chop them up and weld them on the rear and you have a pair of drift tips ;)

 

 

OMG! dude that is what i want to! made drift pipes hahaha for when i get me 4age hah. i think i will look into that more. thanks man!:dance:

if u can weld just do what johno said

if u can weld just do what johno said

 

 

 

 

well..... i can't weld my self but my dad is hell good so ill ask him if he can help me out again. he welded up my roof and just uder the fuel cap. (mad rusty)

Is it school holidays already??

 

Do you think your full-race motor can fill a 2" or 2&1/4 inch pipe?? What else have you done to it??

 

I'd say even a 2" is more than what you need... inch and 3/4 would do, no problem.

 

Somewhere along the way you will pass from "sporty but stock so innocuous" into "please pull me over Officer.."

 

Make sure you have a good resonator on it!

hahaha I'm not in school broo. finished last year

 

hahaha race motor.... dude its a 4 K hahah

 

i havent done anything to me engine yet. cause well its a 4 k do i needa say more? I'm just gonna do a swap down the line.

i spent a day hacksoring my mates exhaust of hes written of ke70 sedan and got the extractors of him, it was a 2 1/2 inch straight through, with pacemaker extractors to twin under sweep pipes, took it to the local exhaust shop and he extended molded and fitted it to my ke70 wagon, only 3 hours labor, he didn't charge me for the extra pipe used. and as far as I'm concerned it sounds like piston sex. :D

in total it only cost about 300 bucks for extractors and whole exhaust plus labor. :)

P.S i think the 4kc carby linkage and extractors share the same bolt so its about an hour more labor, don't take my word for it but :P

what the hell is piston sex?

what the hell is piston sex?

A good sound >.<

Please don't feed the animals :)