Des

ahh ko I'm in QLD so I'm out of the pic. It is really a easy job with the 4ac, I pulled mine out a month ago or so and it took me 2 hours to get it out by myself so.

Pulling out a 4AC is a peice of piss, Where are you located, Id be up for helping you out if your near by.

Pull the motor and box out in one package ?

I'm liking the idea of getting them flow tested and cleaned by a pro but how much would this cost approx ? Keep in mind my tight budget.

Mmmmmm shiny fuel rail. Very dirty injectors. Can i just clean the injectors with petrol or what ?

Your local auto electrian might have a few.

American law forbids you to sell daisy unless its to me.

Must have a video camera running when you 1st start it so we can see you do a back flip when she fires up

Done and done.

Makes me want to strip down the ke70 to the shell and drive it like that.

Need a update soon buddy :)

Its a T-40 same as T-50 minus the over-drive, It will bolt up the same and use the same clutch i would imagine, If its cheap take it.

B Twin SU-style side-draft carburetors C California-spec emissions D Twin Downdraft carburetors E Electronic Fuel injection F Economy narrow-angle DOHC G Performance wide-angle DOHC H High compression like 9.8:1 (example: 5E-FHE) or High pressure charged (example: 2L-THE) i Single-point fuel injection J Unknown meaning (example: 2Y-J Low rpm type?) L Transverse P Unknown meaning (example: 3RZ-FP) R Air injection S Swirl intake (1980s) SE Direct injection (1990s) T Turbocharged U With Catalytic converter Japan-spec emissions X Atkinson cycle Z Supercharged P LPG fuel N CNG fuel From toymods.

PM'ed

On the money there, The first one just doesnt look right.

It comes off but I'm not going to take it off till i have finished it so. Ive been searching for last 3 - 4 months for the correct wiring diagram with no luck, Toyota can't get me one due to it being a import and the dli bigport gze's arnt to commen so its harder again.

hahaha little boy :)

Buy a sealed battey and then you don't need to worry about it, Dunno what will happen if you don't vent it.

I started the wiring today and who wants to do it for me ?

Didnt like the oil pressure in the dash as i couldnt fit any more gauges in there, So i made my own gauge holder. Doesnt look to bad considering i cut the holes with a grinding bit not a hole saw.

I would be hard to breathe at 120mph with out a windscreen.

I want one. http://www.youtube.com/watch?v=k20jZVM1HzU

1.6 badge on the side ke70 have highcam badge on the side but yeah like irokin said search there is plenty of info around.

When all else fails ask the man with the 1G, I lubed :) it up and with some swearing and screaming it went on.

Here is my problem, I'm replacing the seals in my clutch slave and i have got one seal on the piston but i can't get the 2nd one on. How is a seal with a hole 5mm wide ment to fit over a piston that is 10mm wide? As Raven said I'm one angry munchkin, Ive been trying for the last 80mins and no luck :) .