Trev Posted April 6, 2007 Author Report Posted April 6, 2007 Well the harness is 98% complete, I am just fiddling around with the CIRCUIT OPENING RELAY so the harness will be fully complete tomorrow then when it comes time to put it in the car i will wrap it up properly to make it look pretty and i will sort out all the power supplies while I'm at it, This is where i was at about an hour ago:
JoellaRolla Posted April 6, 2007 Report Posted April 6, 2007 Hey this car looks familiar.... lol Great stuff man glad i didnt have to wreak it. :) Lookin good mate have to go for a cruz when your done.
Trev Posted April 6, 2007 Author Report Posted April 6, 2007 Hey this car looks familiar.... lolGreat stuff man glad i didnt have to wreak it. :) Lookin good mate have to go for a cruz when your done. It's a bit different to when you owned it isnt it ;) I will take you for a spin when its finished.
Des Posted April 6, 2007 Report Posted April 6, 2007 Doing well buddy, more work than i am able to do at the moment.
Trev Posted April 6, 2007 Author Report Posted April 6, 2007 Just don't go swapping that GZE of yours for a bloody Bigport 4AGE :)
Trev Posted April 6, 2007 Author Report Posted April 6, 2007 I just got my engine stand and the crane back so I'm pulling the GE out of the seca tomorrow, Shouldnt take long as its only engine mount bolts now.
Trev Posted April 7, 2007 Author Report Posted April 7, 2007 I took the motor and box out earlier and found that the bolts i have to put it on the engine stand are too short so i went out to a few shops and had no luck so now I gotta wait until tomorrow or tuesday to get the bolts to put the engine on the stand, Bit of a setback but i will get over it. Motor and box: After taking the box off:
Trev Posted April 8, 2007 Author Report Posted April 8, 2007 Well i didnt have any luck with bolts today, I need M12x1.25 x 85mm, The largest all of the shops had that were open today is x75mm which i already have so i will be off to blackwoods on Tuesday, While i was in at autopro I thought id get a pic of the intercooler I have on layby:
Trev Posted April 8, 2007 Author Report Posted April 8, 2007 nice work, keep it up When are you putting a GE in the van :)
LittleRedSpirit Posted April 9, 2007 Report Posted April 9, 2007 Come on Trev, hope your on the tools today. Was good to finally meet you too buddy. :)
Trev Posted April 9, 2007 Author Report Posted April 9, 2007 Yeah i did some more today but the harness isnt finished yet.
Trev Posted April 10, 2007 Author Report Posted April 10, 2007 Well $31 later and I finally got the bolts to put the engine on the stand so i took the intake manifold off, Now i can clean it up and put fresh gaskets and seals on it, I wont be doing the head gasket or anything like that tho:
Nitephyre Posted April 10, 2007 Report Posted April 10, 2007 When are you putting a GE in the van :) Maybe when the 4AC dies I'll think of something. Personally I'm leaning towards some 3SG?E goodness I reckon ;)
Recommended Posts