shades

 

...what i would like is a 4agze but the dollars are not available....so a 5k with 30/70cam and twin webbers should be enough waiting for a friend with twin manifold to contact me ......thanks for your interested, will have to come along to a meeting.some time in the future...

Edited April 29, 200719 yr by corolla-ute

Hmmm toyota publica KP30

 

the ute is awsome, shame they never made them in oz i would have one for sure, the front of it looks close to the ke10 i recon

...and that front lower apron is almost identical to the ke20.

hehehe it looks like it would roll over if you tuned the radio too far to either side

Hey what gear box does this have in it?? does it have a removable bell housing??

 

does it look like this?

Hey what gear box does this have in it?? does it have a removable bell housing??

 

does it look like this?

it does not have a removable bell housing

see pic the box on the left is 5speed ke70 i think and the one on the right is the 4speed in the ute as of now, will change shortly

Edited May 2, 200719 yr by corolla-ute

thats just a ke20 gearbox

Jamesrolla

which one ,,,,or both

Edited May 2, 200719 yr by corolla-ute

The one on the right, or bottom. ke20/ke30 pretty much identical.

Edited May 2, 200719 yr by Felix

thanks felix thats the box that was in the ute when i saved it from demolition. hopefuly the 5 speed will fit without any problem...

Drill 2 holes in the xmember, extend the shifter hole, lengthen the reversing light wiring and it should be all good. :jamie:

Edited May 2, 200719 yr by Felix

That is a cool little ute. I like the older styled rims on it better. :jamie:

Very nice ute. And go the 4A-GZE - it'd be just the right thing for a ute.

 

The mustard coloured KP30 fastback/coupe - is that picture of the correct proportions? It looks REALLY short and narrow, like a cross between a KE10 and a KE20.

That is a cool little ute. I like the older styled rims on it better. :jamie:

 

Alot of people have said that , but they are only 14 inch....... will have to get some 5mm machined off the wheel as they are protruding to far for the gaurds..

 

thanks for your comments. it helps a lot to get another persons point of view and ideas....