Evan G

also not planning on keeping this 5k. LOL yea true SLO-030. at $60 for a regrind, its really tempting to put a cam in her...

went and saw it today. it was getting honed/decked as we spoke. my builder suggested going high comp (10:1) for this engine cause they love it, little unsure of this. all thats got is a STD motor, ported head?

http://www.youtube.com/watch?v=8Y5XmAV6yMc http://www.youtube.com/watch?v=Nh5R6VBn63E last 2 are my fav :D

http://www.youtube.com/watch?v=2WuEpFuysOM http://www.youtube.com/watch?v=UOuxTQpxawc&ob=av3e

http://www.youtube.com/watch?v=X_g0pj5LsWs http://www.youtube.com/watch?v=BCOob0MdT4M more coming

one of jakes 5k's had no oil level and NO bungs in the exhaust ports on the head.........?

glugging noise is still there. at 5 degrees of timing i could hear a MAJOR KNOCK from the bottom end. she wont blow up, just slowly die

http://www.facebook.com/pages/Evski-Rollasports/269200303093023 Evski Rollasports delivers again..

I'm running a monoblock for my sub, front and rear speakers are running off the the head unit :y:

thats the rule of thumb anyways. 6x9 have tons of bass from a stock headunit, amped it sounds like a sub. (well i fooled everyone with my wog DOOF DOOF boot rattle)

if you don't have a sub then amp the 6X9, if you have a sub then run em off the headunit, play with the balance and pre outs etc etc

looks like its got a ke30 jap diff :P

why didnt you solder heatshrink most of the connections? but still, spade terminals arent as bad as Scotch locks

have a look on the otherside, see if its slightly glazed aswell. does your handbrake work off the caliper or is it a drumbrake inside the disc brake?

pic

on the last pic its looks like the disc is slightly glazed on the inside edge?

have you tried blasting them with the pressure washer?

negative the a/c V notch is slighty smaller than the standard pulley. annoying me tomorrow and ill get you pics

oo0o0o0o0 didnt see that coming! the slut still lives on in the rc world

that time again. your late light garlic sauce hit is overdue meet at mitcham kebabs around 9ish (northen suburb convoy will leave at 8pm sharp from cooper st/hume hwy bp) will discuss what or if can be f@$ked doing something after we want a big turnout! RSVP here - http://www.facebook.com/event.php?eid=183817498353203&view=wall&notif_t=event_wall NOTE - keybangers optional

the mini spool/lsd centre bolts up to the stock crown wheel. what are spider gears made out of? what does arc / mig weld? you get my point :y:

getting fuel? air? spark? how did it stop running? check your fuel cut off solenoid on the carby (little green plug) or poor some fuel down the carby and see if she kicks

you'll find most ae86/ksev drivers with T series would run a weldy if there poor or a PROPER kaaz 2way if they want it done properly and handle nicely

its a ballast resistor. it lowers the voltage to the coil for better starting and to stop cooking points. you getting spark? is the coil getting hot? bypass/unplug the resistor. it should still start